if you can't do this do not do any repairs on your car please for the love of god
you have to take all brakes and rotor off the hub. then you must spin the hub so the access hole is in front of the bolts,and take all 3 bolts off. then you must pull the hub off of the spline.
Under the Front Passanger side wheel well. You'll need to take off the Plastic Covers inside the wheel well, but only the front two plastic pieces inside the well.
Take the driver side front wheel off and take the wheel well out.. will be sitting in the front
pull the wheel off, remove the two caliper bolts, remove the caliper and the rotor can be removed
Take wheel off, put bearing in
Its by the front drivers side wheel, you must take the wheel off to get to it
take off the wheel, take off the caliper, pull
NO Front wheel must be off the ground.NO Front wheel must be off the ground.
easiest is to take off the front wheel and do the job from there
if its a 2 wheel drive you have to buy a hub assembley. take off the wheel take off brake caliper rotor and the large nut that holds it on and it should tap right off.
Most likely in the front? Might be covered by a plastic cover so you'll have to take that off to get at it.
You will need to take the front spindle off and take it to a shop that can press your old bearings off and new ones on.