0
There is a small tab at the base of the wiper arm where it attached to the pivot. You have to raise the arm up off the windshield and pull the tab(I think) down. the arm will then lock in place suspended off of the windshield. You can then remove the arm by pulling straight up, you may have to wiggle it a bit. Sometimes you will need to pry the little tab a bit to get it to pop out.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What size windshield wiper blades for a 1983-1994 Chevy S-10 blazer?
The 1983-1994 Chevrolet Blazer S-10 (sometimes called "Compact Blazer") takes 16" replacement windshield wiper blades on both sides front. The 1989-1994 models also take a 14" rear wiper blade.
What type of brake fluid does a 2000 Chevy blazer take?
Dot 3 will be just fine.
What size wiper blades fit a 1995-2005 Chevy blazer?
All 1995-2005 Chevrolet Blazers take 20" replacement windshield wiper blades on both sides front. The rear wiper blade is a 14".
How do install a water pump on a 1999 Chevy Blazer?
what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer
What type of oil does a 2000 Chevy blazer take?
It depends on the climate but a 5W-30 works in most cases.
What type of headlight bulb does a 2000 Chevy blazer take?
low beam headlight bulb type: 9006
Where is the shift solenoid located on a 2000 Chevy Blazer?
you have to take the transmissionpan off and it is located at the end closest to the engine.
What if your 2002 Chevy Blazer will not take gas?
2002 blazer want take gas
How much oil does a 2000 Chevy blazer take?
depends of size of engine. 6 cyl about 5 quarts with filter changed
Check gauge light on 2000 Chevy blazer?
The check gauge light on a 2000 Chevy blazer could be several things. The oil could be low or the other fluids may be low. Take notice of all the gauges. One or more may be out of its normal parameter notifying you there is a problem.
What are the procedures for righting up a windshield wiper arm that will not pull the wiper blade up on a 2001 Chevy blazer?
I have a 2004 Chevy Blazer that I believe had the same issue as you. The wiper arm has a plastic covering over it. You will need to remove it. I using a a Flat head screw driver pry it off where the wiper arm bends. This will allow the base of the plastic piece to pop off the rear of the wiper arm. You can now take a 1/2" socket and tighten up the nut that is under that plastic covering. That was the solution for me anyhow. My driver side wiper arm wasn't moving at all, but the passenger side was. Hopefully that works for you.
Where should you look to disable an alarm on a 98 Chevy blazer?
take it to a Chevy place
