0
1. Relieve fuel system pressure.
2. Disconnect the negative bat. terminal.
3. Disconnect the fuel lines and the return lines.
4. Disconnect the PCV hose between the intake plenum and cylinder head cover.
5. Disconnect the vacuum line at the fuel pressure regulator.
6. Disconnect the fuel pressure wiring harness.
7. Remove the fuel rail mounting bolts..
8. Disconnect the fuel rail and with a rocking pulling motion.
9. Detatch the fuel injectors from the rail by:
a. Disconnect the injector electrical connection from the injectors.
b. Remove the injector retaining clilps.
c. Pull the inector out of the fuel rail with a rocking motion.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How to Take out fuel pump in 97 escort?
Some Fords have a removeable panel above the fuel tank that allows removal of the fuel pump. Some have a panel that covers a hole too damned small to get the pump through! On those, or the ones with no panel, the tank has to be dropped.
How do you Replace fuel injector on 2000 ford windstar 3.8?
where is the #5 injector? how long does it take to fix
Where is the fuel injector regulator tbi in a 1991 cchevrolet van g20 5.7l ?
Take off the upper intake, the regulator is on the backside of the fuel injector unit spider.
How do you change a fuel injector on a Mercedes C220 CDI?
Disconect all wiring from fuel rail and battery negative and then you will have to unclip the low presure fuel supply on top of injector the undo nut on side of injector then there is one bolt securing injector in place take out and wolla might be a bit stiff but it'll come out.
How do you fit a peugeot 206 fuel injector?
you have to take the injector rail off. this is located behind the coil pack. then they just pull out.
How do you check fuel injectors on 1994 ford escort?
With the engine running place a mechanic's stethoscope or screwdriver against each injector one at a time and listen for a clicking sound indicating it is working. IF an injector isn't operating or sounds different from the other 3 turn off the engine and take the electrical connection to the injector. Check the resistance with a DVOM across the terminals of the injector. It should be between 11 to 18 ohms. If it's not within this range replace the injector.
Why would a new fuel injector not work on a 1987 Pontiac 6000 LE that has fuel to the throttle body and electrical current to the injector?
The ECM is supposed to ground the injector to make it work. Either the ECM is bad or something that tells the ecm to fire the injector is bad. TAke it to a mechanic.
How do you manuely clean fuel injectors on a 1995 4-runner 3.0?
you could add gas treatment liquid to your gas tank or you could buy the fuel injector cleaner tool and run the system with fuel injector cleaner which is alot faster. other then tht you could take each fuel injector out and spray carb clener through the fuel injector until you see nice spread out spray coming out.
I can take the injector out put it back in and the motor will start for about a minit than quit?
there might be something wrong with your carburetor that has to be a joke! probably your injector is or fuel filter is clogged. have your injectors cleaned or replaced. (there is no carb on a fuel injected engine)
How to change fuel injector on 1994 Honda accord?
take the old one off then put the new one on.
How do you disable a fuel injector on a dodge ram 5.9L?
In order to disable a fuel injector on a Dodge Ram 5.9 L, you will need to locate the Schrader valve along the engine's line. You then will need to take a screwdriver and simply detach the battery cable.
How do you clean fuel injectors in a 1986 Ford F-150 with the 5.0l?
Try the injector cleaner that goes in the fuel tank. If mmore is required, take it to a garage.
