0
How do you take the Ignition Lock Cylinder out of a 1996 Chevrolet Cavalier?
Wiki User
∙ 14y ago
Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Does a 1996 cavalier have a timimg belt?
Both the 2.2 and 2.4 liter four cylinder engines in a 1996 Chevrolet Cavalier use a timing CHAIN
What is the oil capacity on a 1996 4 cylinder Chevrolet Cavalier?
4 quarts with oil filter
How do i replace the ignition lock cylinder on 96 silverado?
Begin by removing the retaining ring at the top of your 1996 Chevrolet Silverado ignition lock cylinder. Slide the ignition lock out and remove the wiring harness. Reverse the process to install your new ignition lock cylinder.
1996 Chevrolet Cavalier won't start is it the fuel pump?
If a 1996 Chevrolet Cavalier will not start, it could very well be the fuel pump. It could also be the starter or battery.
How to route a serpentine belt in a 1996 cavalier?
1996 Chevrolet cavalier shuts off while driving and have to put in natural or park to restart
Which cylinder is No 1 on a 1996 Chevy Cavalier 2?
The Front-Passenger-Side Cylinder
Where is the airbag module on a 1996 Chevrolet Cavalier?
Under right front seat
Where is the coil pack on a 1996 cavalier?
The coil pack, on a 1996 Chevrolet Cavalier, is located on the top of the engine. The coil pack is near the electronic spark distributor.
Where is the oil pressure switch on a 1996 cavalier?
The oil pressure switch on a 1996 Chevrolet Cavalier is on the rear of the engine block. It will be directly above the oil pan.
How do you replace ignition lock cylinder on a 1996 Mercury Tracer?
Begin by removing the retaining ring at the top of your 1996 Mercury Tracer ignition switch. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the cylinder. Reverse the process to install your new ignition lock cylinder.
How do you change an ignition cylinder on a 1996 Chevrolet Cavalier?
Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
Is a 1996 Pontiac Sun Fire 2.2 engine the same as a 1996 Chevrolet Cavalier 2.2 engine?
Yes
