0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How much petrol would it cost to drive from leeds to Scarborough in a citreon Saxo 1.4 liter?
Twice as much as it would take to get half way there ;-)
How much will it cost to change citreon saxo cambelt?
300 give or take 50 , don't go main dealer or could be 4 to 500
Is there a diagram to take apart the outside door handle?
No, there is not a diagram to take apart the outside of a door handle. However, there is a diagram that shows how a door is held together, and from there a person can take apart the outside door handle.
How you take off a outside handle?
You will need to provide more information.
How do you take a airlock out of a citreon c3?
gallon of petrol and a match
How do you remove a 1965 Chevelle door handle?
take inside door panel off and unbolt outside door handle from the inside.
How do you replace door handle on 85 Monte Carlo?
take the inside door panel off and you will see the bolts that hold the handle on, take the bolts out and unhook any linkage to the handle and pull the handle off from the outside of the door, just reverse directions to install the new handle.
How do you replace indicator arm on Saxo?
take it out and put in another
Remove outside door handle on Pontiac g6?
Roll the glass up and then take inner door panel off and deflector water paper, unhook all the rods to the door handle and take the 2 -10 mil. bolts out of the handle and pull the handle out.
How do you replace a paseenger door inside handle and outside handle driver door for Toyota Corolla 1998?
you have to take the door panel off the inside first
How long does it take to replace a outside door handle?
Depends on the vehicle, some can be done in 15 minutes and some may take an hour.
What do you do if the inside passenger handle will not open the door on a 1998 Honda Civic LX?
My problem was the outside handle wasnt working, and the childlock was put on, and door closed. To open a door I couldn't get open from either side, I unscrewed the handle from the inside. I pulled the rod with my fingers, and it opened, then I put the rod on the one from the inside handle. I'm still figuring out how to take the panel off, or get to where the rod is on the outside handle. I cant reach far enough to put the rod back on the handle for the outside, so any help on that would be nice!~
