Want this question answered?
ya no problem
Bad needle and seat Throttle cable misadjusted
Shave the seat! I think you'll be able to lower it an inch or two. Plus you can use handmade lowering kits.
36.4 inches
in front of the passenger seat under the glove compartment on the floor.
Remove the seat and you will see a cover with 3 small bolts with and opening facing backwards. Take the bolts out and pull up on the cover and the filter is under it.
seat height is 39 inches of the ground
I'm not sure on that exact application however most Honda Tanks utilize the same mounting brackets I.E. The CB400 tank will mount on the cj360 however the tank seat clearance is not right. I'd say to check your mounting brakets and see if they line up
it will fit, the graphics might be different
i own a 92 nighthawk and the oil filter is on the front of the engine with a fin cover over it. the air filter is behind the left side cover. you have to remove the seat to get to it. then you'll find a plastic cover with 4 screws. you'll hhave to pull a strip thing from the bottom of the filter and it will come out. hope this helps. wild willy.
Some of the 1991 models have automatic seat belts, in fact, I think all of them do. So, I think it is safe to assume your 92 model came with the automatic belts. I have a 1992 Honda Accord EX and I have manual seatbelts, so maybe it was an option... but not standard....
Essentially on the left rear of the bike in front of the rear signal light, there is a lock with a loop under it and a tab next to it. This operates both the helmet lock and the seat removal. Insert and turn key. push down on tab. While holding tab down pull up and back on seat with strap. Seat pops off. To replace you are going to have to line up hooks on underside of seat with loops in seat area then push forward and down until it clicks.