Best Answer

u must take the top bolts out of the slide then do the middle two and at the bottom u just pick up the door and out this woh job is a two people job my opion is leave it alone it will never line up right aging so if yoiu can advoide it then do so for your own sake

User Avatar

Wiki User

โˆ™ 2006-11-26 01:51:57
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you take the sliding door off a 95 Ford Windstar gl?
Write your answer...
Related questions

How to fix passenger sliding door?

The passenger sliding door of a Ford Windstar LX needs frequent cleaning and checking of the rubbers to prevent jamming. If a door jams a lot during sliding, take out the rubber linings and clean them up before re-attaching.

How can you keep the water out of your 1999 Ford Windstar LX if you had an accident on the drivers side and now the sliding door leaks when it rains?

frame probably bent. Take it to a body shop or, better yet, replace the whole thing!!!

What size battery does a 2003 Ford Windstar take?

The battery group is 65N for a 2003 Ford Windstar

How do you get access to window to put window back on window track on a 1998 ford windstar?


How do you remove a 2000 ford windstar transmission?

take it to a shop.

Can your 2003 ford windstar take E85 fuel?

According to the 2003 Ford Windstar Owner Guide : ( No ) use " regular " unleaded gasoline , 87 octane

How do you take off the interior door panel on a 06 Ford Fusion?

how do you take apart a door panel on an 07 ford fusion

Replace sliding door handles on 2002 windstar?

With the door panel off, you should be able to see how the door lock & latch linkage hooks up - disconnect that.Then you'll likely see a nut on each end of the handle assembly - take those off and the handle's in your hands.See "Related Questions" below for more

What type of oil does a 2001 ford windstar take?

Depends on your climate. Consult the owners manual.

Will a engine and transmission from a 2000 Ford Windstar fit in a 2001 Ford Windstar?

the transmissions are different 2000 takes ax4s 2001 take ax4n motors would fit some sensors make need to be transfered

Is ford Windstar 2000 bulb the front signal light 3157?

According to the 2000 Ford Windstar Owner Guide : The front park / turn lamps take the ( 3157 NAK , amber bulb )

How do you fix the 2002 Ford Windstar's drivers seat?

Unplug it now! Our 2002 Windstar LX almost burst into flames this morning because the malfunctioning Driver's seat drive motors shorted out! Take Windstar to Ford and have the undercarriage framework replaced before yours also overheats and starts a fire.

How do you install a pressure sensor in a gas tank in a 2001 ford windstar?

take old one out, put new one in.

How do you Replace fuel injector on 2000 ford windstar 3.8?

where is the #5 injector? how long does it take to fix

How much gas will it take to fill a 2000 ford windstar at 2.56 a gallon?

A 2000 Ford Windstar has a ( 26.0 U.S. gallon tank ) So , if the tank was EMPTY ( 26 x $ 2.56 = $ 66.56 )

How do you use Windstar 2001 remote?

2001 Ford Windstar vans came with one of two different style key fob.One gives you a total of 5 buttons. Lock, Unlock, Open left sliding door, Open right sliding door and a Red panic button which sounds off the alarm when pressed.The second remote or key fob does not have the option for opening the sliding doors.To program the remote follow these steps *If you're not comfortable doing this take it to an Ford dealership.*Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. (Door locks with cycle to confirm programming mode.)Within 20 seconds press any button on first keyless remote (Door locks will cycle to confirm programming.)Within 20 seconds, press any button on second keyless remove. Door locks will cycle again to confirm programmingTurn ignition to OFF. Locks will again cycle to indicate end of programming mode.

How do you remove door trim on Ford telstar?

take screws out and pull door trim off

What if the sliding door on a 2005 Town and Country does not open all the way electrically?

you should probably take it to get looked at

How to remove door on a 1993 Plymouth sundance?

first you take the fender off the front (only if its the front door) on the side your working on, once its off you will see the hinges and take the bolts off (make sure window is down door shut and that you have someone to hold the door up). all you have to do after that is take the door off by opening it or sliding it off.

Well a reese hitch off Ford Ranger 2003 fit 2002 windstar van?

The Ford Ranger and Ford Windstar were produced on two totally different chassis. This makes putting a hitch from a Ranger onto a Windstar a structuraly problem. If you know how to weld pieces onto or cut pieces off of the hitch, there is always a way to make the hitch work. If, however, you want to just take the hitch off of the Ranger and bolt it up the Windstar, that would never work.

How do you replace the crankshaft sensor on a 99 ford windstar?

easy take old one off replace with new one! simples no

Does the Ford Windstar transmission come out the top or out the bottom for the removal of the transmission?

The Windstar transmission comes out the bottom. Support brackets are used to 'hang' the engine from the top in order to take the trans out. Ambitious project, but certainly doable.

How do you replace an interior Ford Fusion door handle?

To replace interior Ford fusion door handle you must remove the door panel, take off the old handle and replace with the new one, and then replace the panel back on the door frame.

How do you replace a side window in sliding door of a mercury villager 1998?

If it's the opening type, unscrew the latches and take it off.

How many quarts in a oil change on 1996 ford windstar?

According to the 1996 Ford Windstar Owner Guide : With engine oil filter change : Both the 3.0 and the 3.8 liter V6 engines take ( 4.5 U.S. quarts of 5W-30 )