First you take out the driveshaft, then take out the starter "make sure to unhook the negitve battery cable" then take out the exshaust from the manifolds back. "i found it easy to take this out in 1 piece" Then unhook the shift linkage and electical plugs. use a tranny jack or floor jack with a wood block to slightly take some weight off the tranny, then take out the crossmember. then take off the tourque converter inspection plate. then tale off the four tourque converter bolts. then take out the six engine to tranny bolts and pull her out. On my 93 I had to remove the gas tank. But it wasn't bad, just four bolts lower it down and undo the filler tubes and fuel supply but be carful not to brake the clips on them. And also, there's a u shaped bar and shroud that goes bellow the drive shaft, it goes one way so make sure you put it on right or it while rub.
If it won't shift in all the gears.
13 quarts that is including the torque converter
They have the 4R70W transmission.
r 134
Not unless you try to change the whole front end of the car.
no, i believe the 1992 crown vic uses a AODE transmission, while the Lincoln mark viii uses a 4r70w.
Yes it will if the 96 is a standard Mark Vlll, if the 96 is a LSC model it won't.
$38,876
r 134
It's on the drivers side of the transmission.
Drop the transmission oil pan
nitrogen