you will need a 3/8 ratchet, a 10mm, 13 mm short and deep sockets, a few different lengths of extentions and a swivel socket (knuckle) to remove the starter.i disconnected battery terminals. i removed pass. side wheel and the plastic fender well (10 mm and a another real small socket that i cant remember the size). i then let go wires off starter (10 mm and 13mm deep). then i cracked the 2 easy bolts, one on the bottom with the ground and one on the side. then the trouble begins. i could not see the top bolt. i could just barely touch it with my finger tips. i used a 13mm deep with a small extention to a swivel to a 8 inch extention. with one hand up under the chassis and the other feeding the socket setup in abouve the chassis i somehow got it off. took over an hour. once it was loose i couldnt tell if it was on or not alot of the time due too being so loose. anyway it was even worse putting it back on. but i used the same set up. i put the to easy bolts in snug first to hold it in place but not too tight to leave a little wiggle room to get the top bolt started. anyway once the top one is tight it was all easy. i used tread lock on the bolts cause i wasnt sure how tight i got the top bolt. anyway, hope tis helps. took me a little over 3 hours to change this starter. crazy. good luck.
No, the Explorer is 5x4.5 bolt pattern and the F-150 is 5x5.5 bolt pattern.
Location of starter on 89 ford f150
the bolt pattern for 1976 f150 with the eplorer package is 5x5.5
On the Starter
how do I disable computer on Ford 150 1998
Bolt Patterns are different ; 1992 Ford Ranger = Bolt Pattern: 5-114 1996 F150 = Bolt Pattern: 5-139
Check the bolt pattern first...Ford had some pattern changes in between those years. If it a 6 bolt rim to a 6 bolt hub then yes.
No, the bolt 219 W is not the correct size bolt for the 1989 Ford F150. The bolt pattern for that make/model of vehicle is 5.5 x 5 lug. The F150 is one of the larger trucks that Ford manufactures.
Instructions are in the box the starter came with or go to the manufacturers web site. Not a fun job unless you've done them before & have access to wiring diagrams
5 on 135mm
no
check your starter or starter relay.