Want this question answered?
Can you please tell me where the location of the Crank Shaft Position Sensor is on a Nissan Pulsar N16 2000 model?
A cam sensor tells the computer when number one compression stroke is happening, the crank sensor tell the computer when to fire the sparkplugs.
The camshaft sensor for a 1.9 dti is located on the gearbox. it is at the end close to the motor, held in with a single bolt.
The cam shaft sensor is device that uses the "Hall Effect" to tell the ignition control module and/or the ecu ( depending on type of vehicle ) where the cam shaft is during it's rotation so it can fire off the engine coil(s) and open the fuel injectors at the correct time.
hai my car is ford fiesta zetec 2003 5door ,in my cay o2 sensor have fault .can you tell me how many o2 sensor are there and were is location
I have a 2003 Dodge Ram 5.7 4x4. Can you tell me where the IAT Sensor is located ? I have a G-Force chip to install. Also can you tell me the 2 correct wires to use ?
I just purchased the throttle sensor for a 2003 Buick rendezvous and was wondering if anyone could tell me where it located and how easy is it to put in.
The cam shaft position sensor uses the "Hall Effect" to tell the ecu ( car's computer ) where the cam shaft is in it's rotation. This information is used by the ecu to fire off the coil ( or coils ) and the injectors at the correct time.
SENSOR not center. It reads the revolutions of the crank shaft to tell the computer how fast it's spinning.
call around to auto part stores if you have a autozone near you they can check them for free
Can someone anyone please tell me where is the Crankshaft Positioning Sensor on a kia sorento 2005 and I also need a diagram
A crank sensor plate , is attached to the crank shaft . it has little notches in it , that tell the ecu what piston is top dead center, sending the spark and fuel to the correct piston at correct time assisted by the cam senor which tells the ecu what position the valve is in.