0
How do you tell if your ignition coil is bad on your dodge neon?
Wiki User
∙ 12y ago
The car will have a misfire on one or two cylenders. You can take it to a local shop and get them to put a scan tool on it with a cylender contribution test to see what ones have a miss
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What causes a 1993 Dodge Stealth to Misfire on two cylinders?
bad coil pack on cylinders, find or pull ignition wires and you can tell by no loss of power.
How do you tell a 2000 Dodge Neon ES from a 2000 Dodge Neon Highline model?
Look in your VIN number. If in the first 6 digits there are the letters ES then your car is an ES.
How is a ignition coil installed in a Mercedes Benz E320?
i dont know can u tell me
How do you tell if your engine is a non-interferance in a 1995 dodge neon sport engine?
On a Neon engine if the timing belt breaks the valves can bend.
How much antifreeze do you had to a 2001 dodge neon?
How cold does it get where you are? Look at the container the coolant comes in. It will tell.
How can you tell if you have an HEI ignition?
Well on a small block Chevy there will be no coil wire going from the top of the cap to a coil. What you can do to see the difference is go here.
How do you tell if timing belt went out on a 2000 dodge neon?
Engine will not start and run if the belt has broken.
Was there a recall on dodge neon for peeling paint?
If you call your local dealer with your Vin number, they can tell you if you have any recalls.
Where is the horn relay in a 2002 dodge neon?
the horn relay for the 2002 Neon is located under the hood. It is inside of the relay box, the lid should tell you which relay is for the horn.
What is the output volts of a coil on a lawn mower?
well you first need to tell someone is it electronic ignition or dose it have points ??
How do you tell what ignition coil is bad on 1999 maxima?
Unplug ignition coils one at a time until you find the one that doesn't effect the rpm's.That's the one that's bad.
How do you view computer codes on a 96 dodge neon?
You need to have a diagnostic meter to read the codes, then book to tell you what they mean.
