Want this question answered?
Test Drive - 2002 Ford F-150 EcoBoost Torture Test was released on: USA: 30 April 2011
How do I test body control module and is it hard to do..
Green with With DCA attivate that you can get at ford dealer or parts stores it uses test strips to check PH level to prevent cavation.
How do I test body control module and is it hard to do..
If by control module you are referring to an ignition module then you need to remove it from the distributor and take it in to a shop for testing ,it requires special equipment for testing.A new module runs from $50-$100 depending on model
where on a 1995 ford f250 7.3 engine is the number 8 fuel injector located I have hod a buzz test done on the truck thay said the number 8 fuel injector was not working so I need to know wrere is the number 8 fuel injector is located
Unit test can be done within a single module Cohesion of a single module/component is the degree
the wiper moder is pulling to many volts, consider replacing. this should fix your problem. however I would first test it with a meter.
Check the spark plugs and wires Do a compression test
it could be that the timing is a little off check the timing with a timing light, it could also be the ignition module which is very difficult to test on your own you can take the module to advance auto parts and they can test it for you!
It sounds like it could be an ignition module. Take it off and take it to Oreilly's or a parts store that can test it. It is the fuel filter inline by the engine,replace filter and it will run fine.
It depends on which module you are talking about. But yes, I've had them test good cool and bad hot.