answersLogoWhite

0


Best Answer

You should not have to. There is a belt tensioner that keeps the belt tight. If the belt needs to be tightened, you probably need a new tensioner, or you have the wrong size belt.

User Avatar

Wiki User

โˆ™ 2006-11-22 03:05:54
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you tighten a drive belt on a 1994 Chrysler Town and Country?
Write your answer...
Submit
Related questions

Does a 1994 Chrysler Town and Country have airbags?

A 1994 Chrysler Town and Country only has a driver side airbag.


1994 Chrysler town and country fuel filter location?

The fuel filter on a 1994 Chrysler Town and Country is along the underbody, near the center of the van.


Will 1997 Chrysler town and country transmission fit a 1994 Chrysler town and country?

No.No.


Is the 1994 Chrysler Concorde front or rear wheel drive?

Front.


What kind of freon for a 1994 Chrysler town and country?

R134a


Where is the starter solenoid on a 1994 Chrysler Town and Country?

on the starter


Will a 1994 3.8 Chrysler Town and Country Transmission work in a 1998 3.8 Chrysler Town and Country?

No, all of the sensor plugs are different.


What is model number of 1994 Chrysler Town and Country transmission?

It is a 41 TE


What are the torque specifications for tightening a CV joint on a 1994 Chrysler LeBaron?

the only thing to tighten is the spindle nut and i think that was 125 ft/lbs.


What grade of Oil for 1994 Chrysler town and country?

i usually use 5W-30


What type of transmission fluid for Chrysler Town and Country 1994?

Mopar ATF+4


Which other transmission is a replacement for a 1994 Chrysler Town and Country transmission?

A 1993,1994,1995 Dodge Caravan, Plymouth Voyager, or Chrysler Town and Country with the same engine would have to same transmission.


How do you replace starter on 1994 Chrysler Town and Country van?

You can replace the starter, on your 1994 Chrysler town and country Van, by removing the starter wiring. Remove the three retaining bolts. The starter will come off. Reverse the process to install the new starter.


In what year was the Chrysler LHS introduced to the general public?

The Chrysler LHS is a full size front wheel drive car based on the Chrysler LH platform that was marketed during the 1994 to 2001 model years. The Chrysler LHS introduced to the general public in 1986.


Where is the bulkhead connector located on 1994 Chrysler Concorde?

where is the bulkhead connector located on 1994 Chrysler concorde


When was Chrysler Neon created?

Chrysler Neon was created in 1994.


When was Chrysler LHS created?

Chrysler LHS was created in 1994.


Why does ignition off draw fuse blow on contact in a 1994 Chrysler town and country van?

You have an electrical short.


How many gallons fills the gas tank on a 1994 Chrysler Town and Country?

It should hold twenty gallons.


Lost keys to ignition 1994 chrysler town and country van?

Call local dealer or locksmith for replacement.


Where is the power sunroof motor located on a 1994 Chrysler LHS?

Where is the power sunroof motor located on a 1994 Chrysler LHS


How many oxygen sensors on a 1994 Chrysler Town and Country?

It has one oxygen sensor located on the rear exhaust manifold.


Were is the fuel filter in a 1994 Chrysler town and country?

It should be under the vehicle, close to the passenger's side rear wheel.


Where is the fuel filter located on a 1994 Chrysler Concorde?

It is located about 1/2 way up the right underside of the vehicle. The same on a 1997 Chrysler Concorde How do i have to replace the filter Chrysler Concorde 1994? How do i have to replace the filter of Chrysler Concorde 1994?


Where is the kill switch located on the 1994 Chrysler lhs?

Chrysler does not have a kill switch.

Study guides

๐Ÿ““
Create a Study Guide