Want this question answered?
To tighten a loose side view mirror on a 2002 F150, take out the old screw and screw in a slightly larger one. It is also possible to tighten the mirror by using plumber's tape around the original screw.
Pop off the plastic cover on the back of the mirror. Then release the mirror by sliding the mirror forward. Then you can see the mirror bracket and the loose screws. Tighten the screws and replace the mirror. It takes about 2 seconds when you know what your looking for!
The rear view mirror on a 2000 is glued to the windshield. Very carefully it can be pried loose. It may be necessary to insert a thin wire or razor edge to break the seal.
My right hand side mirror on my 2002 jeep liberty is loose the mirror part only. How do i tighten it?
The only way to tighten the rear view mirror on a Vauxhall Corsa is to replace the base. It is glued onto the window and gluing a new one or re-gluing the old one is the only way to fix a loose mirror.
there should be a screw on the mounting plate for your mirror. most of then are a hex head bolt the just holds the mirror to the mounting plate. look at where the mirror connects to the windshield, that's where the bolt should be.
My belt is too loose, I have to tighten it.
the mounting tab is held in place by a spring clip and cant be tightened if the mounting or the pivots are loose the mirror will have to be replaced. an universal one can be glued to the inside of the wind sheild. it shoul be in the center and about 3 inches down from the top
To tighten a loose drive belt, find the pully that is connected to the belt. Tighten the pully and then hold the belt in place using the adjuster belt. Check out the related video to see an example of how this is done.
You can not tighten a T-Rod end up. If it is loose then replace it.
Cannot tighten, Replacement is the only fix for loose transfer case chain.
No, it will need replaced.