You need to use either a pneumatic or electric impact driver/drill. There are ways to do it with a large torque wrench, but you would need a flywheel holding tool.
you have to take the primary clutch off and start the belt on the secondary and use the sleeve on the primary to walk the belt on the primary shaft. Then reassemble the clutch and tighten down the nut. simple..
To tighten the steering you just tighten the nut under it and then your done. NICE
The same way you tighten any other nut. Use the appropriate tool to the recommended specifications.
Tighten the proper size of nut. Or loosen same.
How do you get big nut loose on engine pully 0n 83 FXSB Shovelhead primary belt drive
A wrench is used to tighten nuts. Socket wrenches are a type of nut driver.
Mitchell 1 OnDemand5 service manual recommends, from GM's service information, to tighten the drive axle nut to 140 N.m (103 Ft. Lbs.).
Best just to remove the nut and replace it with an new one, or grab a pair of pliers and tighten it that way if you absolutely need to.
The head stem is located under the handlebars. You have a nut on top of the top triple clamp, that is your head stem nut.
while turning rotor ccw, tighten nut to 17 ft/lbs.loosen nut and while turning rotor cw do a final tighten of 17 in/lbs
dont worry about why, just take another nut with same threads and tighten it on top of the existing nut
You loosen (1/2 turn) the 15mm nut that locks the idler pulley. Then from under neath you turn the 13mm bolt that will tighten and loosen the belt. Be sure to tighten the lock nut when done.