The most important aspect is to make sure everyone is Safe. Using an OTLVISE to move the Granite will reduce the working load and allow you to roll it. Clamps as well to lift it with. Many patents with this NEW and Innovative tool
You can tile over existing tiles if the wall is sturdy and none of the old tiles is cracked or loose. If there are only a few loose tiles, remove and clean them, then reinstall them with fresh adhesive before retiling the wall. Epoxy tile adhesive bonds with existing tiles, making it one of the best options for tiling over an existing tiled wall.
You start from scratch with plywood, a vaper barrier, concreteboard, thinset mortat, and tile.
Don't do it. Beat the old off with a hammer.
It is possible but I would not reccomend it. If possible remove the old tile before laying the new tile. If you want to avoid removing the old tile you can lay a cement board over the old tile before installing the new tile.
I have never covered up floor tile before without removing the old tile but I have covered up an old back splash with new wall tile and did nothing to go over it just used the white pre mixed wall glue to install the tile right over top with no issues.
Sure can, but if its waxed tile you should rough it up unless there's a chance its got asbestos in it. Then use a primer sealer over that top to give the glue something to bind to. Also remember that the new tile is only as good as the old tile that's down. If the old stuff comes loose your new tile job is shot.
It would be better to remove the old tile, then put your new tile in it's place. If you tile over the old there is a chance it could come off and your new tile with it. I know of an adhesive swimming pool tile border made of 4mil liner, its a peel and stick called borderlines adhesive tile manufactured by Jedco Products. All the internet websites carry it and it looks great, it would stick right over the old tile, this could get you by until your ready to remove the old tile.
no the tiles have too smooth of a finish and other tile will not stick to them need to remove old tiles and then lay new
You can, but you want to be sure the ceramic tile is not cracked or broken, make sure it is even, and not loose. It is reccomended that you you always remove any old tile before tiling. You can always lay a subfloor on top of the old tile to ensure your new tile was crack or pop out.
The new tile can be glued to the old ones. If possible, stagger the new ones so that they attach to two tiles. If you have to cut the first row in half, you can use the piece you cut off on the other side of the room.
Though people do tile over tile, it's really not recommended. The underlying surface can make or break a tile installation. Preparing that surface is the most important step. So I'd remove the old tile, prepare the surface properly and then install your new tile. This will insure the long lasting beauty of your fireplace tile.
Yes, but you need to scrape or chip off as much of the old mortar as you can - both from the back of the tile and from the floor, just enough to ensure that the tile will set level.
I wouldn't - you risk the old ones flaking loose and ruining the new job.
Yes, as long as the tile is only 1 layer, the floor is sound structurally, and you use a very high quality latex fortified thinset. If the old tile is cracking, those cracks will only transfer to the new.
On You Tube you can see a how to video on how to put in and how to tile and install a kitchen counter with a sink. http://www.youtube.com/watch?v=5Ip1eQztuAg