• Nissan
  • Chevy Trucks and SUVs
  • Isuzu Trucks
  • Truck Racing

How do you time a 1993 2.3L Isuzu truck?

User Avatar

Wiki User

βˆ™ 2011-09-12 22:36:26

Best Answer
Timinghere is how u time a 93 Isuzu 2.3l. there is an arrow on the cam gear u set it at straight up and down and if u pull the timing belt cover off there is a notch out of the crank gear u aline it dead on the bold above it and u should be in time if u get a timing spec sheet u will understand what im talking about
2011-09-12 22:36:26
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: How do you time a 1993 2.3L Isuzu truck?
Write your answer...

Related Questions

What is the oil capacity of a 23L 4cyl 1993 Ford Ranger 5spd 2wd?

The engine oil capacity for the 1992 2.3L is 5 quarts (includes filter).

What is the firing order for a 1993 ford ranger 23L?

Here you go: Copy & paste into your browser:

What are the timing specs for a 96 Ranger 23L SOHC 4 cylinder and will the crankshaft position sensor cause it not to crank?

haha i asked this question and i can answer it now. I finally got my truck on the road !!

Which measurements is equal to 2300 dL?

23l bro.

How may cups in 23 liters?

About 97.2 cups to 23L

What is 23 liters to English gallons?

23L equates to about 5.05929 Imperial gallons.

What engines can be used as a replacement of the 23L Isuzu pickup motor?

The only replacement for your 2.3 is another 2.3 or a 2.6 out of a '88-91 Trooper, '89-94 Amigo, '88-95 Pup, or '91-96 Rodeo. information has been edited because the original poster has no clue what they are talking about.

What would cause your 96 ranger 23l to backfire through the breather?

More than likely it has jumped time. This is a comman problem with older timing belts. Or in colder weather.

What is the firing order of a 93 Ford Ranger 4 cylinder 23L and how are the cylinders numbered on the block and where would the 1 plug wire be located on the distributor cap?

23L 4cylinder motors dont have distributors the cylinders on the block are numbered (front to back) 1234 and the firing order is 1-3-2-4 Correct Firing Order: Correct firing order is 1-3-4-2; Haynes Manual #36071, 1993-2005 Ford Ranger Pick-ups

Where is the oil drain plug on a ford ranger 23L?

On my 1993 Ranger, 2.3L, it is a bolt between the two front wheels underneth the engine. Should be pretty easy to spot. The oil filter is on the drivers side of the engine, towards the bottom. Also easy to spot.

How do you rebuild a 1988 ford ranger 23L engine with fuel injection?

Take it to jasper they rebuild any motor.

How much is 23l in millimeters?

A litre is a unit of capacity. A millimetre is a unit of distance. The two units are therefore incompatible.

How many ounces are in 58 and 23 liters?

58L = 1,961.21 fl oz 23L = 777.723 fl oz

Is the neutral start switch the same thing as the neutral safety switch on a 1997 ford ranger 23l 4cly?


Where is the EGR valve located on a 1996 Ford Ranger 2.3?

egr valve location on a 1997 ford ranger 23l

Where is the horn relay located on a 95 olds achieva with 23l quad four?

My Horn on my 1995 Oldsmobile Achiva does not work. How do I get it to work?

Where are the vacuum lines on a 1987 Ford Ranger with a 23L with fuel injection located at?

they stems from the intake manafold then run in several places

Where is the crankshaft position sensor located on a 1994 Olds Achieva Quad 4 23L?

You will fine it right on side of the starter on the front side of the motor

What is the name for the filter connected to the crankcase vent hose of your Mercury Topaz 1992 23L engine?

I believe you are talking about a PCV valve. PCV means Positive Crankcase ventilation.

How do you find the firing order for a 19'93 ford ranger 23L?

Here you go: Copy & paste into your browser:

What volume of hydrogen at STP is produced from the reaction of 50.0 g of Mg and the equivalent of 75 g of HCl?

The answer is 23L. There is 25.0 g of excess reagent that is left over in that problem.

What could be wrong with your 91 Ford Ranger 23L if it won't start or get spark after you took out the coils and replaced them if all the wires look good?

bad crank shaft position sensor

Where do you find overhaul information for a 2004 mazda-3 23L?

The dealer may be able to provide specs for you. Best to ask when it's not busy if they can print off what you need from their service computer.

How do you find overhaul information for a 2004 mazda-3 23L?

There is a CD for the overhaul information on the Mazda 3.I can forward it to you if you need it.Just sendyou e-mail to me on Thanks E.Muchie

Where is the PCV valve located on a 97 Ford Ranger 23L?

The PCV is located on the driver's side of the engine. It is at the same level as the spark plugs, in the middle of the engine. It is not seated in the oil cover. It is seated in the oil diverter.