0
If its a 3.5 tdc mark on the crank with the one on the block and if you make sure you press the tensioner pin down with like a vise and put a very small Allen wrench through it I did not have a vise I just got it together and slowley altered back until it just tightens all up and the drivers side camshaft will break your finger if you turn it to far it will grab and rotate under its own power have no clue why I used a wrench and wedge it plus it doesn't have to be right in the middle of the dots just in them mine were off between and shes made about 4000 highway miles good luck
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How long would it take approximately to replace the timing chain on a 1997 Chrysler lebaron?
The last Chrysler LeBaron was in 1995. Both engines available that year had timing belts.The last Chrysler LeBaron was in 1995. Both engines available that year had timing belts.
Where is the fuel pump located on a 1988 Chrysler newyorker?
In the fuel tank, it is electric high pressure
Where is the crank sensor on a 1994 Chrysler 3.3?
where is the crank positioning sensor on a 1996 newyorker van
Does a 1995 Chrysler town and country van have a timing belt or timing chain?
Your 3.8 liter V6 has a timing CHAIN
Can a broken timing belt on a 1995 Chrysler sebring ruin the engine?
Yes.
Does a 1995 3.8l engine have a timing belt?
The Ford 3.8L V6 engine has a timing chain. The Chrysler 3.8L V6 has a timing chain.
What are symptoms of a bad timing belt in a 1995 Chrysler?
engine cranks over but will not start.
Why would a Chrysler 1995 would backfire?
timing , burnt valve, fuel/carburation prob.....most likely a timing/ignition problem.
How many quarts of oil does a 1994 Chrysler new yorker take?
The 1994 Newyorker (3.5 Liter 6cyl ) takes 5.5 quarts with filter .
Where is the water pump located in the engine of a 1995 Chrysler LHS V6?
It is inside the front, driven by the timing belt.
What does the timing belt on a 1995 Chrysler new yorker line up with?
The sprockets have marks that line up with marks on the case.
Do you have to change the timing belt if you replace the water pump on a 1995 chrysler cirrus?
No, but it is recommended. If the belt breaks, valves can get bent.
