Wiki User
∙ 13y agoby taking the liner away!
Wiki User
∙ 13y agoPhotosynthasis
yes it can be saved. You will have to put points in the ground and rent a diaphragm pump or buy one and dewater the pool. Most instances the diaphragm pump has to run while the liner is being put in because if you turn it off and you have a high water table in ur area, any water it sucked out of ur pool will begin to fill up again.
. I cannot think of any reason to "shrink" your pool. If however you wanted to do this, it supposed it is possible by trimming the correct amount of aluminum border and buying a new (properly sized) liner. Good day sir.
As far as I can tell, it is not structurally harmful to vinyl pool liners, but can fade their coloring. The first year I had a pool, I made the mistake of dumping 1/2 pound of calcium hypochlorite (bleach) in one spot in the pool, which caused the liner to turn from blue to white, but did not cause it to leak.
A vinyl liner floats because of excessive ground water. This usually happens because of extreme weather conditions such as rain or snow. A broken pipe, proximity to bodies of water i.e. creeks, ponds, and lakes are also causes of floating liners.Also if the pH value of the pool is to low (to acidic) because the acidic water will eat away the stuff in between the tiles of the pool.
Stick a hose in it and turn the tap on. Keep an eye on it as it fills so you can pull any creases out of the liner before there is too much water pressure on it.
A dark pool liner might cause a very small increase in water evaporation, but nothing significant. The dark pool liner will raise the water temp a bit which, in turn, may increase the evaporation rate. But, the evaporation rate is much more dependent upon the air temperature and humidity than on the water temp, so the increase in water temp would only have a very small effect on the overall or net water evaporation rate. Hope this helps ... yes, it will, and it could be a significant increase.
A professional installer is usually the the best option to replace your liner but in a nut shell 1) Drain the water 2) Remove the skimmer, return and main drain face plates. 3) Remove the Old Liner 4) Clean and prepare the bottom and walls 5) Place the liner at or in the pool as the manufacturer specifies 6) Start to hang the liners bead in the pool track 7) Once the bead is in all around the pool and the liner is aligned turn on vacuum 8) If everything fits start to add water 9) When there is about 12 inches of water in the deep end the main drain face place can be installed 10) When there is about 12 inches of water in the shallow end the vacuum can be removed and usually the skimmer and return face plates can be installed and cut in
4.5 miles
The only reason the pool would turn green would be if the Baquacil is not entirely out of the pool and it reacts with the Chlorine.
Concrete cannot turn into a liquid under normal conditions. However, concrete can behave like a liquid when it is freshly mixed and in its fluid state before hardening. Once concrete cures and hardens, it becomes a solid material that cannot revert back to a liquid state without undergoing significant changes.
You haven't mentioned if the pool is a vinyl liner, fiberglass or gunite. What you will do is ruin the surface of the pool. Plan on replacing a vinyl liner, re-plastering a gunite pool and I'm not sure what effect dirt would have on a fiberglass. That being said: Drain and blowout all water in all the pipes and seal with threaded plugs. Remove the pump(s), filter and heater - all the equipment and drain and clean them. Remove any pool lights and turn off the electrical to the pool.Answeror to avoid destroying the pool if you think you may want it later simply install a solid safety cover. balance the water and winterize the equipment check and adjust pH every few months Rather then using dirt to fill it in use sand with just a layer of dirt on top for plants or grass