answersLogoWhite
Ask
Cadillac DeVille

How do you turn off a 1996 Cadillac DeVille ABS light when diagnostic tests have found nothing wrong with any of the systems?

424344
Answer

Top Answer
User Avatar
Wiki User
2015-07-15 20:07:27
2015-07-15 20:07:27

To turn off the ABS light on a 1996-1999 deville you would need to check to make sure that all of your abs sensors are plugged into the back of your bearing assemblys on the wheels. if they are then the abs sensors are bad and you would need to get those replaced. $120 new, $15 used. Alot of gm cars use the same bearing assembly so check at the junk yards for more than a cadillac.

1
0

Related Questions

User Avatar

There are about 30 different sensors which monitor emission control systems components. It could be any one of them. Have a dealer run a diagnostic scan.

User Avatar

Diagnostic Retrieval Systems.

User Avatar

it means your struts need to be checked and or replaced. the deville has an automatic ride control that eletronically controls the ride height of the vehicle front and rear. there are passive struts available from the dealer..or aftermarket air ride or passive systems available for it on the net. i suggest the dealer or a reputable mechanic do this as the electronic control has to be disabled if the passive struts are installed.

User Avatar

Brent J. Liu has written: 'Medical imaging 2010' -- subject(s): Radiology Information Systems, Picture archiving and communication systems in medicine, Database Management Systems, Image Interpretation, Computer-Assisted, Image Processing, Computer-Assisted, Diagnostic Imaging, Methods, Congresses, Data Mining, Diagnostic imaging 'Medical imaging 2010' -- subject(s): Radiology Information Systems, Picture archiving and communication systems in medicine, Database Management Systems, Image Interpretation, Computer-Assisted, Image Processing, Computer-Assisted, Diagnostic Imaging, Methods, Congresses, Data Mining, Diagnostic imaging

User Avatar

On all 91-93 Deville cars. remove the glove box unit and it is DIRECTLY above the opening, just to the left of where your dash says "Cadillac" The smaller box toward the drivers side is the Chime module for lights, seat belt, etc. You want the larger black box with A LOT of wires coming out. There will be two 7mm (or 9/32 US) bolts that are a little tricky to get to. Programming is done through the cars computer diagnostic connector under dash. Only cars with the RPO option code AUO in the trunk will have this FACTORY module. A lot of these cars had add on remote / alarm systems since you had to buy a 400 dollar security option package to get this when the cars were new back then.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.