0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why does your ignition key not turn on your 2000 Plymouth Breeze?
Had the same problem with my 1999 Breeze, all I had to do was spray the key 10w40.
When trying to start 1999 Plymouth breeze the key won't even turn what is wrong?
Just spray key wd-40, and work the key in the ignition.
Where is the turn signal flasher located on a 1998 Plymouth Breeze?
I have a 96 Plymouth breeze-- to get to the flasher, you have to take the steering column cover off. major pain in the butt.
Why does my1996 Plymouth breeze turn over with the key but will not start?
Fuel? Spark? Compression?
How do you turn of the check engine light on a 1997 Plymouth breeze?
make sure gas cap is on all the way and drive it a few tanks and see if it goes off by itself.
1999 Plymouth breeze stop running at a light and it will not turn back over but you still have power what could be wrong?
My 96 Breeze did the same thing. Sometimes it would start again, other times it didn't. I took it to the dealer (after an independent shop said "you need a new engine") and it turned out to be the cam sensor. It has run like a champ ever since.
How do you remove thumb twist screw to get to the battery on a Plymouth Breeze?
Push up on it turn ninety degrees and pull.
Plymouth breeze wont turn over but it cranks?
My car starts but it shuts off it says ck engine
How can I turn off check engine light long enough to get smogged on a 1996 Plymouth breeze?
You can reset the light with an OBD2 scan tool, but it will come right back on unless you have the problem fixed that set the trouble code in the first place.
Why would a 2000 Plymouth breeze crank and not turn over?
Have you checked for fuel and spark? Camshaft sensor and or crank sensor will cause that problem as well!
If you have 97 Plymouth breeze with a 2.0 timing was off on your engine and you went to turn the camshaft half a turn to get it at the right mark and it wont turn all the way?
Valve could be hitting piston, not good. Valves may be bent.
What are the head bolt torque specifications for a 2.4 Plymouth breeze?
25 ft lbs, 50 ft lbs, 50 ft lbs, 1/4 turn.
