on dashboard their is a small plat that pops off its buy where you put your key in use a flash light look in you will see it
That requires a scan tool.
Just found out that it must be reset at the dealership with a diagnostic computer
There are many scanners that will turn off light. Chrysler drb scan tool ,snapon scanner. Needs to be turned off with tool. I think auto zone does free analysis.
CALL AUTOZONE U MAY RUN THE CODES ON IT OR MAY CHANGE OIL OR CALL DEALER CALL MORE THAN ONE PERSON FOR ANSWERS
Quest for the Mighty Sword was created in 1990.
Mighty Force Records was created in 1990.
Mighty Like a Rose was created in 1990.
Quest for the Mighty Sword - 1990 is rated/received certificates of: UK:PG USA:PG-13
The 1990 2.4L 4cyl mighty max has a timing BELT. Very easy to change.
Disconnect the battery wait a minute then reconnect this should turn the light off.
From 1989 on, the maintenance required light is turned off using a DRB-II Scan tool that most professional shops and the dealer have. Or, if you are Cheap,,,er, I mean Cost Effective orientated, like me and wish to spend the cost of a service call bill for other things, a strategically placed piece of black electrical tape makes the light "disappear" too. if you disconnect your battery cables and leave them disconnected overnight, the check engine or maintenance light usually goes off unless there is really something going on in your vehicles system. i did this for my van twice and it works just fine. i was told that the maintenance lights come on at different mileage intervals just as a vehicle precaution for maintenance, and usually there is nothing wrong.
You can reset the light by disconnecting the battery cable for about 5 minutes, then reconnect. You will need a scan tool.