Want this question answered?
The procedure is in the manual. Turn the ignition to the on position, fully depress the accelerator 3 times within 5 seconds, then turn the ignition and start the truck. The light should flash then go off. www.trailvoy.com All the answers for your Envoy or Trailblazer!
Turn the light nob to the left and a orange light should come on under the lights nob.
AnswerActually all you have to do is: ignition on - engine off - floor the gas pedal 3 times When you turn your ignition on (spot right before you would turn on the engine) push the gas pedal all the way to the floor and allow it to release each time. When that is complete turn your vehicle on. A 2005 Trailblazer will blink its change oil light a few times and then turn off completely. In your manual scratch out "take your car to the dealer" and write this down this procedure instead.
The same as you do in the 1968 Buick Wildcat
Just turn the ignition key one click forward and press the gas pedal 5 or 6 times should do it
Turn on Ignition - depress gas pedal 3 times- turn off ignition
Turn on Ignition - depress gas pedal 3 times
Check fuses as the battery change should not initiate a "No Start" condition.
Turn the key on, engine off. Hit the gas pedal to the floor 5 - 6 times. shut the key off. It's now reset. Only reset it when the oil is changed.
push the little button right under your light switch
How do you turn off the change oil light on a Chevysilverado 2002
The seat should have a sensor inside that when enough weight is in the seat it will automatically turn on the airbag system for the passenger.