where is the cam shaft position sensor on a 98 ford explorer 4x4 4.0 sohc 4x4
It will for maybe 3 seconds , when the key is turned to the run position , before you start the Explorer
Is door ajar light on also?
" lost battery feed "
the wiring to the mirrows is cut or tore into i had one l8ke that after i rewired it it worked fine
No, the door on a 1998 Ford Explorer will not fit a 1992 Ford Explorer.
Bring t a shop that has an ABS scanner to determine the problem
I have the same problem - but my third brake light slightly flashes when the car is of (Explorer 1998). I have replaced the "stop light" switch with no improvement at all.
I assume it is the same as the 1998 Ford Explorer four door : There is a " CHECK GAGE " light ( just to the left and above the tachometer ) The light comes on if the engine coolant temperature is too HIGH , the engine oil pressure is too LOW , or the gas gauge is at or near empty
what are the wheel alignment specs for 1998 ford explorer
the brake light switch is mounted above the brake pedal on the metal lever
Our ford explorer was a light green color
The check engine light is the light shaped like an engine, or the light that states Check Engine (Soon). If this light comes on, it is time to see what the issue is with the engine.
On a 1998 Ford Explorer : Would you mean the air bag ( Supplemental Restraint System , SRS ) warning light in the bottom area of your tachometer
how do you remove a fan blade from a 1998 ford explorer
A 1998 Ford Explorer uses refrigerant 134a
How do I change the head gaskets on my 1998 ford explorer?
Yes , the socket is live so you can use the cigarette lighter without starting the Explorer or turning the ignition key to the accessory position
HDF Explorer was created in 1998.
No , a 1998 Ford Explorer has shock absorbers front and rear
1998 ford explorer transmission reverse won't engage, acts like it is in neutral.
1998 Explorer uses a PATS II system with a transponder in the keyhead.
There are two catalytic converters on the 1998 ford explorer.
the cam shaft position sensor is located in the front of the motor on a 5.0 it is in the place of where the distributor was on older models it should be about center in the front