Want this question answered?
The abs light is on because there is a problem with the abs. Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself after a short drive.
THere should be an ABS warning light that comes on briefly along with all the other indicator lights when you turn the ignition on.
The ABS indicator stands for the Automatic Brake System indicator. It can be reset by restarting the entire control display.
Yes, there is an ABS light indicator in the 2004 Toyota Highlander model.
What indicator are you talking about? Turn signal, emergency flasher, check engine light, abs light, oil light, temp light, alt light, etc. We can't read your mind.
It will either be the brake wear indicator or the abs sensor Check if it goes to the brake pads it's the wear indicator If it goes to the hub it's the abs sensor
Turn the key off, then off. The ABS codes are nor cleared and the light off unless a problem has been detected again. If the problem is detected again, check for ABS codes. Not that most common problems are bad speed sensor or bad control module.
vss sensor
Bring to a shop that has an ABS scanner to determine the problem
Most auto parts stores can plug into the computer of the Honda, detect the problem, and turn off the indicator.
ABS equipped vehicles have an indicator light to warn of trouble. The light should come on for a couple of seconds when you turn on the key. If the light were burnt out, you could look under the hood for an abs controller near the master cylinder, or wiring to the brakes for a speed sensor at each wheel.
A common cause for an ABS indicator light not coming on in a 2004 Toyota Highlander even when the ignition is started is electrical issues.