Want this question answered?
On my 99 Suburban, the alarm activates when you press the lock button on the remote twice.
The alarm is reset with the remote or by unlocking the door with the key.The alarm is reset with the remote or by unlocking the door with the key.
the remote has been lost and a new remote has been purchased. i had to remove the fuse to get the alarm to stop. how can i reset the alarm? So i can program the new remote.
alarm doesnt wrk neither does door locks with key
.
There is a switch on the left hand side of the steering wheel. The remote is not a standard alarm remote. It is on your key. I found that it is really easy to accidently hit this switch when cleaning then your remote will not work.
An alarm remote is a remote control for an alarm system. A remote alarm is an alarm that rings somewhere far away from whatever set off the alarm.
Unlock the drivers door with the key or insert the key into the ignition switch and turn the switch to the on position will turn off the alarm.
unplug the car battery this should reset the system. If it doesnt, i presume you do not have the remote for it? I assume the doors are locked also? put the key in the door turn it left, right, left. this should de-activate the system. If there is a kill switch, also known as a valet switch it should be under the dash on the drivers side near where the fuse panel is.
Unlock the driver door with the key or use the remote.
how to program another remote from a existing car alarm remote immobilizer
I looked up the owner's manual - I also have a 2001 Chevy Astro Van, and there is a setting called resyncronization. If you hold both buttons down, the lock and unlock, for 8 seconds, it will recycle the alarm and synchronize it to the key fob remote. When the alarm goes off, just hit unlock twice like you normally would, and it should be fixed.