First remove your ignition lock by inserting your key and turning to the ON position (do not start it). directly below the ignition cylinder there is a hole, using a Phillips screwdriver, ice pick etc insert it into the hole and push directly up. once you've disengaged the pin locking the cylinder in just pull it out. Once its out there is a plastic piece on the top of the keyway sandwitched between two pieces of metal, simply remove the top piece of metal and re install.
hold odometer reset button down with key off, turn key while holding down reset button until lights flash and go out
You must push key and turn.
To program a new key for a 2003 Honda Pilot, you'll need to have the new key and a working master key. Insert the master key into the ignition and turn it to the "On" position without starting the engine. Turn the key to "Off" and remove it, then insert the new key and turn it to "On" for about 10 seconds. After that, turn it back to "Off" and your new key should be programmed.
Turn key off ,push and hold reset button on dash,turn key on continue to hold button until light goes out
Replace the ignition switch, or try the correct key.
To reset the maintenance reminder on a 2007 Mercedes SLK 280, turn the ignition key to position 1 (do not start the engine). Press the gas pedal three times within 10 seconds. Then, turn the ignition off and back on to confirm that the maintenance reminder light has been reset. If the light does not turn off, repeat the process.
Turn completely counter-clockwise.......and pull out.
Battery is probably dead.
Turn Key to position 1, hold in trip odometer reset while turning key to position 2. Hold down until service reminder starts flashing, then release odometer reset.
Most steering columns will unlock once you put the key in and turn the ignition on. If you are having trouble unlocking the steering, you should turn the steering wheel back and forth with the key in.
Turn key on,Do not start. Then push gas pedal all the way to the floor 3 times being sure to let off of it each time. Then turn key off and then start engine.
To reset the reminder light on a Toyota, you need to turn the ignition key forward without starting the vehicle. You then need to pump the gas peddle 3 times within 10 seconds and it will reset the reminder light.