The control lever for wipers on the Transit is able to move up and down (for operating the front wipers), but also can be moved towards and away from the driver to control the rear wipers. Push the wiper lever away from you (while seated in the driver seat) to turn off rear wipers.
Use the same switch for the front wipers. Once the front wipers are switched on, the rear wiper will come on as well. However, a reverse twist of the switch would turn on just the rear wiper.
you need to put your side lights on then then turn it on from in the back
it is on the same lever you turn your front wipers on with but you twist the the last inch of it
how do i turn off rear wiper for my Montana van
According to a drawing in the 1997 Ford Escort Owner Guide : On the right side of the steering wheel column is a lever that operates the windshield wipers . On the inner part of the lever , towards the steering wheel , is a selector switch for the rear wiper / washer on the wagon
The wiper control arm on the right of the steering column pulls forward to control the rear wiper. Push in the end button to spray wiper fluid. Push up to turn wipers on with arm pulled toward you. Push arm back away from you to return to front windshield wipers. Took me forever to figure this out as this was a work vehicle.
The rear wiper are turned on when you pull the wiper control arm (right side of steering column) toward you. Just push it back to the center position & the rear wiper will be off.
My wipers come on when the turn signal is used - Ford recommends replacing a revised mulifunction switch (turn signal switch)
ford transit wont turn over ignition light and battery light on
Check the fuse for the wipers and replace the turn signal bulb.
why is it after I hooked up the linkage for my wipers the wipers stay in the upright position after I turn them off.
What does a remote starter have to do with the wipers? Just turn them off when stopping the car, and then when you use the remote starter, the next time, the wipers will not come on. If the wipers are not on then they will not work, no matter if you are using a remote starter or not.