pull up the lever to 4wd hi while traveling below 50mph. Use command trac, (manual 4wd) only when surfaces are slick, slippery, gravel, sand, dirt...never on dry asphalt.
It is part of the hazard push button switch.
The turn signal flasher relay on a 2003 jeep Liberty is in the fuse box that is below the glove compartment. Look for a large box type plug in with three prongs inside the fuse box.
If you're looking at the car from the front left
Read the owner's manual or call a local service shop.
how do you replace a turn signal bulb on a 2004 jeep liberty. I can not find screws or a panel to go through
Low of coolant or overheating.
turn the key to run (not start) 2 times with in 5 seconds and watch the odometer
You put the hand break on, turn the traction control off and avs, then, finaly find a switch called 4x4 and click it.
pull out on the end of the lights switch
pull out on the end of the lights switch
Turn it counter clockwise.
Turn it counter clockwise.