Want this question answered?
turn the car off and apply the parking brake, when you turn the car back on, or to the accessory position, the daytime lights will not come on until you lower the brake lever
Look at page 3-175 of your owners manual. It tells you there.
Break lights come on when you step on the break, they do not come on when the head lights are turned on.
If you have a key that is already programmed to your Outlander, use that key first. Place it in the ignition and turn to the "on" position five times. A light should come on your dash (looks like a car with a key inside). Once that light comes on, turn to the off position, remove your first key the place the "new" or unregistered key in the ignition and turn to the "On" position (not start). This should program your key to your Outlander.
try replacing all sets of fuses for the hazard and the tail lights.
One of the bulbs is burnt out.
You cannot turn off the Daytime running lights on a Mitsubishi Galant without cutting the wire. This is because the car is set up to have these lights on at all times during operation.
check high/low beam relay and switch
NOT SURE BUT YOU CAN TAKE IT TO ADVANCED AUTO PARTS AND THEY'LL CHECK IT ON A COMPUTER FOR FREE.
You can change the rear lights in your 2009 Ford Fiesta by removing the interior panels behind the tail lights. Push the light clip and turn it. the light will pull out to be replaced.
i have found the answer in the owners manual on some galants and others the dealer had to do it hooked up to a computer.
check fuse 4 or 5 under the hood, i can almost promise its blown, i had the same problem. my plate lights, tailights and dash lights didnt work.