Depending how bad it is you can try taking the spark plug out and soak it in diesel fuel. If it froze up solid you may half to take it apart and drive it apart. If you half to do that you might be better of to buy anew or used motor might be cheaper in the long run.
Hope this helps.
As of my last knowledge update in January 2022, Briggs & Stratton engines are primarily manufactured in the United States. The company has production facilities in various locations, including Wauwatosa, Wisconsin, and Poplar Bluff, Missouri. However, it's essential to note that the status and locations of manufacturing may change, so it's advisable to check the latest information from the company or reliable sources for the most current details on Briggs & Stratton engine production.
Get the model # and click the link I will post.
Head Bolts should be torqued at 185 inch pounds
Briggs and Stratton does not release specific compression values. Anything above 120 psi should be just fine, around 90-100 and you're most likely due for a rebuild. A better test is a leakdown test, with can help in determining where compression is being lost.
The top two rings are both compression rings and the third is the oil control ring set, Nominal is 0.010" and minimum is 0.006" with 0.014 for the oild ring set.
A Briggs and Stratton 17.5 horsepower engine can use any type of small engine motor oil. A heavy duty motor oil is recommended.
between 9 and 11hp
How many horse power is 342cc
5.5 to 6 h.p.
If oil is leaking on a Briggs and Stratton 18.5 horsepower engine, it is likely a seal is bad. It could be the manifold or the bottom seal.
The spark plug gap for a Briggs and Stratton 13 horsepower engine should be .030 inches. A spark plug for this engine may be purchased at an auto parts store.
The spark plug gap for a Briggs and Stratton 13 horsepower engine should be .030 inches. A spark plug for this engine may be purchased at an auto parts store.
with a big freagin hammer
5 hp and 6 ft llbs tourqe
You can adjust the valves on your 17 horsepower Briggs and Stratton engine by turning the adjustment screws. The adjustments screws will determine how much fuel goes into the piston chamber.
0.030 is the gap for briggs and stratton 4.5 hp mower
were can i find a wiring diagram for a 18 hp briggs and stratton engine