Spin 3 times to the right until you get to your 1st number, spin to the left past your second number once then keep spinning until you get back to your 2nd number, then spin to the right until you get to the last number. then pull the lock to open. By Emma
I purchased a used 1999 Chevy Malibu and had to replace the glove box because the latch was broken. I purchased another a the local salvage yard and I want to know how to take the lock out of the old door and install it in the new one.
above the glove box, shouldn't need to remove the dash just the glove box.
glove box
fuse box will be in or under the glove box and the fuse will be blow stopping dash lights from coming on .
GU6 is just in indicator of the differential ratio a gu6 is a 3.42:1 ratio. it could be single track, limited slip or gov lock. if it is gov lock you should also have a g80 code in your glove box. if so and you tow or have tall tires be ready to replace when master pin breaks
First, unlock and open the glove box if possible<*>. Next, look at the back side of the lock the are two diagonal screws holding the lock assembly to the glove box door, remove the screws/bolts on the lock and remove lock assembly. <*>If you cannot open your glove box beforehand u will need a flat head screw driver to pry it open.
I don't know the answer but any glove box lock is a joke. I would just replace it but never lock it.
Make sure you are not using the valet key. Amanti's come with a set of keys (2) that can unlock everything, driver's door, glovebox and trunk lid. There is also a third key designated for valet use, allows you to disable trunk release and then lock glove box with master key. This way the valet cannot look throughout the trunk or glove box but he can lock the car and start it.
No you cannot. that key is only used to unlock the door or trunk from the outside, or lock the glove box.
Yes, the glove box opens manually only when the key is inserted in the ignition. When you lock your car with remote you can observe the glove box key locking. So, when you lock your car, the glove box is also locked.
if there is not a key hole you cannot lock it.
I had the same problem the default factory code is 0000...
Open the glove box, unscrew the three screws next to the lock, tap lightly and it will come out.
Using the master key.
It doesn't have the key lock but it could easily custom installed.
THESE RELAYS ARE UNDER THE GLOVE BOX. REMOVE THE LOWER PANEL BENEATH THE GLOVE BOX. YOULL SEE THE RELAYS ON THE DOOR SIDE OF THAT AREA NEAR THE CROSS BRACE THAT SUPPORTS THE GLOVEBOX AND THE PANEL YOU JUST REMOVED.
If the Vaultz lock box has a combination lock, you need the combination to open and/or reset it. If it has an actual key lock, one can be ordered from the company.