upset -------------------------------------------------------------------------------- Upsetting the rivet is to compress the rivet during the installation process. That can be done with a rivet gun to "hammer" the rivet against a bucking bar, or to use a rivet squeezer to compress the rivet.
You can expect to pay between $4 and $20 for a hand held citrus squeezer. A well made stainless steel or cast aluminum squeezer can be had for less than $10.
A pop rivet, of course.
You have to use a squeezer to get the juice out.
to use a pop rivet gun you have to get two pieces of metel and drill 2 holes into the metal
A Molly Rivet is much like a standard rivet except the shank on a molly rivet mushrooms out to grip a hollow wall. they still require the use of a rivet gun, they just have a much larger gripping area so as to not tear out of the hole they are installed into.
Many - most are associated with fragmentation of the rivet material. Burrs break off and cause eye damage, rivet guns incorrectly set cause hand / wrist injury, rivet holes enlarged which allow the pneumatic plunger to fire a rivet through
There are two kinds of rivet tool, the pneumatic rivet tool and the manual rivet tool. Press the trigger and push the metal into the rivet, then release the trigger so it is held in place. Push the head of the rivet through the holes in the metal then pull and release the handle consecutively until the pin pops.
Most types of manufacturing industries, such as chemical and car manufacturers, use blind rivet equipment. Blind rivet equipment is used in industries that make items where rivet joints can only be accessed from one side, such as plastic piping and some aircraft parts.
because it is good
Yes you can.
You can start by riveting these two pieces of steel together