Want this question answered?
Get a turkey baster to empty the master cylinder and refill with new fluid Bleed the individual wheel cylinders and calipers until new fluid runs through them Make sure master cylinder doesn't empty during procedure
Change in steps Get a Turkey baster and syphon brake fluid from master cylinder and refill with new Every time oil is changed Take out the moder cap, and then pour in the fluid.
Get a turkey baster to syphon brake fluid out of master cylinder resevoir Re-fill master cylinder with new brake fluid Bleed brakes Longest line to shortest
A couple ways. Use a turkey baster. Open the bleeders and allow it to gravity bleed.
Use a turkey baster to suck the brake fluid out of the master cylinder Replace with new fluid Bleed each wheel until new fluid runs out MAKE SURE MASTER CYLINDER DOES NOT EMPTY DURING PROCEDURE
Use a turkey baster to suck old fluid out, refill with new fluid.
The scientific term for turkey baster is pipette.
usually this happens when a new set of pbrake pads are changed get a turkey baster and correct level to max line the fluid need room to expand when pedal is depressed
Drain the coolant reserve chamber and refill with new coolant. Can use a turkey baster ot remove hose from chamber.
Turkey baster
Use a turkey baster.
Locate and identify the master cylinder. Remove top and suction out brake fluid ( A turkey baster works well for this. Remove all steel brake lines, primary and secondary. Unhook wires for low level sensor, Unbolt and remove master cylinder. Install new or rebult one same way opposite order, Refill with DOT and Toyota approved brake fluid. Then VERY important: bleed all four corners until you have NO air and clean clear brake fluid, at least 3 times even if the first or second go~around seems to have no air. Please dispose of used brake fluid in a responsible manner. After 100 miles bleed them again.