You unhook the two wires that lead from the ignition to the electrical.
The 1999 Jeep Cherokee ignition coil used a black wire for the negative wire. The negative wire should be on the left post.
Yes
Take the ignition wire apart from there take a jumper wire and go from the red to the black
Yellow wire is your ignition wire.
Check all the wire coming out of the ignition switch, make sure that theres no bare wire or shortage between them or to the body..If wires are ok, your ignition switch needs to be replaced.. the switch doesn't turn with the cylinder..
Possibly the neutral switch is at fault.
several things. Dirty carb, poor battery, spark plug/wire is shot, throttle issues. i know this sounds stupid, but check the gas too.
purple is the trigger wire for the starter. Yellow is the ignition wire.
there my be a problem in your wirering stick a tester in there to see if its al flowing right . if not you may nee to re wire it all
The ignition wire that run to the cap is red. The one that to the key ignition is blue.
To wire an ignition barrel in the Citroen Saxo, begin by disconnecting the wire at the negative terminal of the battery. A lead wire has to go to the ACC terminal on the ignition barrel. The starter relay wire goes to the ST terminal and the ignition wire is connected to the IGN terminal.
It may be that the "Hot wire" is connected to the Hot side of a fuse in the fusebox.