You will need a stepdown transformer to convert 3-phase 480V down to 120V. An electrician is going to have to do this.
AnswerIt depends on the country in which you live. In European countries, for example, a 230-V single-phase supply is obtained between one of the three line conductors and the neutral conductor. No transformer is necessary, as European three-phase, four-wire, systems operate at 400/230 V.
There are many configurations of 240 volt plugs. To give you the correct pin connections the amperage of the plug must be stated and the type of appliance of equipment the plug is to be connected to. With this information it can be explained what wire terminates on which pin.
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
To answer this question the amperage of the plug must be stated.
Most 480 volt lighting systems are operated through a lighting contactor. A smaller control voltage is used to control the lighting contactor.
If it does not come with a plug on it, no. If it is made for direct wire, then 99.9% chance is that it is a 240 volt unit. If you plug it into a 120 volt outlet your water will barely get warm.
I am guessing this is a 220-240 Volt plug. There is 220-240 V between Black and Red and the Green is ground.
It could if you don't get the terminals and motor wires on the correct terminals.
Wire is wire - is doesn't matter what voltage you use. However, if you are changing the voltage on a device from 240 to 120, given the same power requirement, you may need bigger wires for the doubled current (and increased heat of resistivity).
It depends on the voltage, but if you are using it on a 240 v system, it's quite OK to use wire that can take 600 v (if you had to buy the wire, you would be spending too much).
Change the cord/plug on the stove to a four wire cord/plug. When installing the new plug remove the grounding strip that connects the center lug in the stove wiring block to the frame of the stove. Connect the white wire from the new plug to the center lug. Connect the green wire from the plug to the stove frame.
If it does not come with a plug on it, no. If it is made for direct wire, then 99.9% chance is that it is a 240 volt unit. If you plug it into a 120 volt outlet your water will barely get warm.
I am guessing this is a 220-240 Volt plug. There is 220-240 V between Black and Red and the Green is ground.
Yes 220 & 240 are considered the same.
Yes <<>> In North America, a three wire 120/240 volt system uses a neutral wire. For 240 volts two "hot" wires are used with no neutral.
no
no
Potato. Not really a question is it?
A four wire plug suggests to me that it is for split voltages. 120/240, hot - neutral - hot - ground will be the four blade connections for shore power in the US. With UK shore power three wire there will be no neutral as you know it. 120 volt equipment will not work. If there is a special berth for 120/240 shore power that is what you will need to tie up to.
It could if you don't get the terminals and motor wires on the correct terminals.
Depends on what is plugged into that plug and the current it is drawing.
no