Want this question answered?
The Chevy starter does not have a ground wire, the starter grounds through the starter casing.
It would help to know the year, But I would say that it is the knock sensor wire and it should be pluged into the knock sensor that is screewed into the side of the engine block just in front of the starter.
Yes and it should be in your fuse block. Chances are that it is a relay fuse and you won't be able to tell if it is blown or not.
The starter needs a large wire from the battery and a wire from the starter switch. These are connected to the solenoid that is attached to the starter.
The starter of the 1994 GMC Sierra 1500 pickup is located on the dashboard. It is usually attached by a small wire.
what is the proper way to wire the starter for a 2000 chevy impala
dark green
I have a 93 chevy pick up all I want is to hard wire the starter so the the truck will start with just wire straight from the starter to battery
mark s is for start mark r is resitor
Your starter solenoid is the ropund part attached to the top of your starter it has the little wire to trigger the starter drive to engage the flexplate and a big battery wire to spin it hope this answers you question
im stuck and I need help
assuming the batt.is fully charged,it may be the solenoid not engaging the starter motor.you can remove the starter motor and solenoid and run jumper wires to it .if starter does not spin,it may be the solenoid not engaging the starter.keep hands and clothing away from starter when doing this test!also,you did not mention if the solenoid wire was fastened to starter when you replaced it.usually purple color on chevy.good luck