0
I am not familiar with your vehicle, but trailer lighting wiring is just about the same for all vehicles. Therefore, this discussion will of necessity be generic in nature.
Usually, the "kit" for/with the trailer wiring includes the connector plug for attaching to the tow vehicle light system.
That kit usually has very detailed and specific instructions on what wire colors mean and how to connect into the tow vehicle wiring system.
Read and study that instruction sheet UNTIL you know it by heart!!!!! Then, and only then attempt to make the connection into the tow vehicle light wiring system.
In general, there are four wires:
A ground wire.
A wire for tail lights.
And two wires, one each for left and right turn signals.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Put new lights on the boat trailer brake ights come on when releasing truck brakeAny ideas?
Make certain that the wiring is connected properly but also, check the ground wire. Don't count on the hitch to be the ground for the trailer. There should be a ground wire that goes to the electrical plug, make certain that it is connected properly.
Copper wire to map lights in a 98 expedition are bad Where do you get a new map lights with new copper wire?
Something that specific would be a dealer item. Go to your local Ford dealer.
How to I figure out why my boat trailer lights do not work?
Check the ground on the trailer..and then check ur hitch and ball..i bought a new ball last night and the lights didnt work until the ball got a little wear on it.
What would cause the tail lights but not the brake lights on a 1989 New Yorker to fail?
bad connection at the bulb, short in the wire or a bare wire. hope it helps. duboff
What do I need to hook-up under the hood There is no power to the center pin for the trailer plug at the bumper I am trying to energize my new electric trailer jack.?
The center pin of a seven blade trailer plug is for reverse lights, not power. What type of truck is it? What trailer plug do you have...
Built custom bed for 2004 dodge 1ton how do you wire up LED taillights?
The only difference between LED lights and your old lights is the bulbs. Wire the new lights up using your existing wires and you'll be fine.
What would cause the fuse to the tail lights and dash lights to blow on a 1993 Mazda 323 when the lights are turned on?
A couple possibilities: 1) the insulation from a wire is damaged and the wire is in contact with the frame of the vehicle. 2) A socket is damaged or the bulb is put in wrong or damaged. 3) if the vehicle has a trailer light plug, it could be wired wrong or damaged. 4) the light switch or relay (if it uses a relay) is faulty and must be replaced. Another 2 posibilities are, if a new stereo has been fitted the earth for the stereo may have been connected to the illumination wire which tests as an earth when the park lights are off. To test this just unplug the stereo, replace the fuse and turn on the lights. If it stops isolate illumination wire and connect steroe to a proper earth. The other thing could be that illumination wire has been disconnected but not isolated properly and is shorting out behind radio.
What to do if you want to install new recessed lights in the kitchen the lights that are in the ceiling now do not have a box therefore nowhere to put the ground wire which is on the new light?
See View Discussion below.
When was Cleo Ridgely born?
Cleo Ridgely was born on May 12, 1893, in New York City, New York, USA.
When did Cleo Mayfield die?
Cleo Mayfield died on November 8, 1954, in New York City, New York, USA.
How do you install new halo headlights in your 1998 528i There is an extra wire harness with the new lights?
How to install headlights to a BMW 528i?
Why would the lights stop working after a new CD player was installed?
Someone knocked a wire loose.
