There are three terminals
One is ground
One is High beam
One is low beam
Two terminals are parallel and one is at a right angle to the other two.
The single is ground
The other two you will have to figure out by powering them
short in the wire or they are all on one wire
Not enough information. Lights? Pumps?
i would dare say u have a dead short or ground problems or wire rubn with brake wire
The only difference between LED lights and your old lights is the bulbs. Wire the new lights up using your existing wires and you'll be fine.
The wire that lights up inside the globe is the filament.
to wire the license plate lights you must have lights and wire them to the scooter.
Incandescence of a finely coiled tungsten wire.
The tow bar comes with a color coded wiring harness. The tail lights, blinkers, and brake lights are hooked up to a terminal near the trailer hitch of the towing vehicle and then the tow lights are plugged into the socket for the car lights. There are four wires. The brown is the brake lights, the green and black are blinker lights, and the white wire is the ground wire.
how do i wire my brake lights on my Honda 1000
The ground wire for trailer lights is typically white.
check for a loose ground wire
It depends on the number that's on the fog lamp. It usually comes in H3 or H4