0
disconnect the battery with the lights on and then press the horn for 5 seconds.
This will erase the codes in the chip.
Then reconnect the battery and the service light should be off.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you turn off the service soon light on a 2003 land rover discovery?
Hold the reset button
How do you reset the check engine light in a land rover discovery?
hoe do you reset the check engine light in a 1995 land rover
How do you reset service light on rover 75?
you have to take to a rover dealer to put out the service light
How do you reset a service engine light on a 2003 range rover?
reset service engine light
How do you reset the service light on a supercharged range rover?
range rover supercharge service light off
How do you reset a service engine light on a land rover discovery 1998?
Inside panel passenger side under dash by door.
How do you reset service light on land rover discovery 3?
You need what is called a "Service indicator reset dongle" it is a very small computer that does all the programming for you. Your local Land Rover Dealer will have one and I'm sure they will be happy to help you, normally without charging you too.
95 range rover discovery reset oil light?
You can reset the oil light in your 1995 Range Rover Discovery by scrolling to the oil life display. Hold the scroll button in until the oil life goes to 100 percent.
How do you reset land rover Lr2 service light?
Blackbox Solutions Inc
How do you reset a check engine light on a 1998 Land Rover Discovery Series 1?
You can reset the check engine light, on your 1998 Land Rover, by repairing what ever is causing the light to stay on. You can determine the cause by using a diagnostic tester.
How do you reset the brake light on a Land Rover Discovery II?
Unfortunately it can only be reset via computer. You also may try turning your key off then on again
How do you reset the maintenance light on a 2000 land rover discovery?
If you are talking about the service engine light you have to use a handheld scanner to identify the problem. After fixing the problem you use your scanner to erase any codes stored in the ecu in order for your light to go off.
