answersLogoWhite

0

How does a flywheel work?

Updated: 10/22/2022
User Avatar

Wiki User

12y ago

Best Answer

The starter has gear on it that comes into contact with the flywheel while in start phase. It spins the flywheel which in turn starts the engine. The flywheel turns continuosly with the engine. The transmission is connected to the fly wither by manual clutch setup(manual transmission) or by a viscous coupler (torque convertor in a auto transmission. The fly wheel turns the transmission which then moves the car. When it is in gear of course. I hope I explained this ok. Good luck.

it then sucks a dick and boosts

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How does a flywheel work?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Could the wrong flywheel make the starter not work?

yes. a starter made for the 168 tooth flywheel would not engage a 153 tooth flywheel.


Will a high torque starter work on a flat spotted flywheel Cause the regular starters just hit the flywheel.?

The answer to the question is no. If the flywheel is ground or damaged it needs to be replaced.


Will the flywheel off a 305 work on a 350?

yes


1968 Chevy 6 cylinder flywheel part 3791021 Will it work on a Chevy 283 or 327?

Yes, it is same flywheel.


Will a 1983 350 sbc flywheel work on a 1973 400 sbc?

No. The 400 is externally balanced and requires it's own flywheel.


Will a 1986 305 standard flywheel work on a 1993 350?

no


Will a flywheel from a 350 work on a 305 chev truck?

yes


Will your flywheel from your Chevy 6 cly work with the 350 you are putting in?

NO.


How does a dual mass flywheel work?

goo goo ga gapoo


Will a 67 Camaro flywheel work on a 67 lemans?

If you are asking if a small block chevy V8 flywheel (most common engine in a 1967 Camaro) will work on a Pontiac V8 (most common engine in a lemans), the answer is no.


How do you get the flywheel puller to work i bought the suggested puller but I can't get the flywheel to release?

have you removed the flywheel bolts? I've never used a flywheel puller, you shouldn't need one, theyre not a press fit. You may have to let it sit over night, then tighten it some more as descirbed in this article. http://hubpages.com/hub/removing-outboard-flywheel


Will the flywheel off a 350 work on a 305?

It will on anything older than 1986. Probably work on the newer ones too.