It will increase the total volume, but it will hardly affect total mass. Remember the definition of density as mass / volume.
It depends on what you're measuring: the density of the aluminum or the aluminum and the space inside the can. If it's the density of the aluminum only, it doesn't change much. If it's the density of the aluminum and the space inside the can, the density greatly decreases as you are getting rid of the air, and therefore the volume, inside. This also depends on if you are using your foot or a garbage compacter.
The density of the metal doesn't change when you crush a can.
The density is the ratio of mass to volume. It doesn't matter what size the piece of metal, if it is the same metal it has the same density, 8.4.
No change. Crushing just pushes out air.
The density is a physical characteristic of all materials.
Yes, the overall density would be less than if the rod were pure metal.
It depends on what you're measuring: the density of the aluminum or the aluminum and the space inside the can. If it's the density of the aluminum only, it doesn't change much. If it's the density of the aluminum and the space inside the can, the density greatly decreases as you are getting rid of the air, and therefore the volume, inside. This also depends on if you are using your foot or a garbage compacter.
Air bubbles would make the volume you read in the measuring cylinder increase from the actual volume of theliquid. so when you add in the metal, there would be an increase in the volume of the metal than it really is. the mass of the metal cannot be affected by air bubble because this is the amount of matter in the metal. This increase in volume causes the density of the metal to reduce from its original value. since mass is constant, density is inversely proportional to volume. As volume increases, density decreases.hope that was helpful.
Every metal has a density.
Low Density a Metal?NO!!!!
Low Density a Metal?NO!!!!
The density of the metal doesn't change when you crush a can.
follow the top radiater hose to where it goes to the motor there should be a bubble looking metal houseing if it is it will be inside.
what metal has a density of 5 g/mL
The density of the metal will remain the same. However because the volume of the object has been reduced the overall density will increase
The density is the ratio of mass to volume. It doesn't matter what size the piece of metal, if it is the same metal it has the same density, 8.4.
Indeed yes. Density is defined as mass per unit volume. If all the mass were concentrated in one lump, your boat would no longer float. If the metal walls of the boat were a little thinner, you'd have more boat volume, and lower density.