Want this question answered?
In signal processing, sampling is the reduction of a continuous signal to a discrete signal. A common example is the conversion of a sound wave (a continuous signal) to a sequence of samples (a discrete-time signal).
the bandwidth and the signal to noise ratio
A: Noise effect an analog signal by adding or subtracting from the signal
Electricity, Heat, Natural obstacles during daylight hours
i have no signal on my phone i have signal on my phone i have no signal on my television i have signal on m y television the signal has been interupted i dont know the hand signal i need to know the signal what is the signal strength teach me the hand signals what is the signal for danger i have little signal i have high signal i have no signal how much signal do i have how do i tell how much signal i have is there a sign for signal by the way you already put it in a sentence by asking a question lol
The height of collimation is the height of the line of sight. It is the vertical distance of the horizontal plane through a telescope.
diaphragm
yes it does affect the signal.
Collimation is used for telescopes to make sure the telescopes are perfectly aligned. The reflector will not produce the best image if the aligned is not just right.
Collimation Error: Collimation error occurs when the collimation axis is not truly horizontal when the instrument is level. The effect is illustrated in the sketch below, where the collimation axis is tilted with respect to the horizontal by an angle α: Figure ( ) In this particular example, the effect is to read too high on the staff. For a typical collimation error of 20", over a sight length of 50m the effect is 5mm. If the sight lengths for back sight and foresight are equal, the linear effect is the same for both readings. When the height difference is calculated, this effect cancels: δh = (b + s. α) - (f + s. α) = b - f That is, the effect of the collimation error is eliminated if sight lengths are kept equal.
The brain
This term is used in surveying. 'Height of collimation' means height of instrument.Generally this term is used while doing levelling i.e. Measuring elevation of given point.
it is line set out by the optical axis of the instrument ( level). so it is just an imaginary line that describes the ray of light that allowes us to read different values from the leveling staff. this term arose from the fact that in differential leveling in surveying we must construct horizontal line of sight, but due to collimation error the collimation line (i.e. line of sight) will not be 100% horizontal (by horizontal we mean tangent the level surface at the instrument position), instead it will be slightly deviated. so what we are looking to achieve when we eliminate the collimation error (using the 2 peg test) is a horizontal line of collimation.
the difference between both are: Primary transducer:The Mechanical device which converts physical quantity to be measured into a mechanical signal. Secondary tranducer:The Electrical device which converts this mechanical signal to the electrical signal.
the difference between both are: Primary transducer:The Mechanical device which converts physical quantity to be measured into a mechanical signal. Secondary tranducer:The Electrical device which converts this mechanical signal to the electrical signal.
No.
The primary affect on the Earth is on our ionosphere