I doubt that you even will be able to start the engine.
The input sensor reads the speed of the transmission input shaft.The output sensor reads the speed of the transmission output shaft.The transmission computer uses these sensors to help time the shifts, and to run the speedometer.The input sensor reads the speed of the transmission input shaft.The output sensor reads the speed of the transmission output shaft.The transmission computer uses these sensors to help time the shifts, and to run the speedometer.
There is no input speed sensor. The output sensor is located on the driver side rear of the auto trans case.
They both measure the rotational speed of whatever they are installed into.
yes the have a speed sensor a input and out put the input allow your transmission to change gears and the output speed sensor allow your speed to register on your speed domitor
It only has an output spensor.
I think this should answer your question The vehicle speed sensor (VSS), which IS MOUNTED ON THE TRANSAXLE, is a "Hall Effect" switch.
The input and output speed sensors are located on the front of the trans. They have two wires and the input sensor is closer to the engine.
there are 4 wheel speed sensors, 1 transmission input, 1 transmission output speed sensor.
probably $150.. cos i had to pay 300 for both the input and output sensor....
IF the speedo does not work that means is not getting a signal from the output sensor. Also delayed and erratic and mushy are controlled by the input sensor speed battery level must be correct/ idle speed all this is to the battery of sensors opening and closing at proper perspective intervals.
Once you register, there is a pdf located at the following link that can show you both the Input and Output speed sensors. http://www.hyundai-forums.com/t5491-input-output-speed-sensors.htm
There is an output coming from the VSS (Vehicle Speed Sensor) and an input going into the ECM (Engine Control Module).