use of a impact would make life easier, make sure all the towing wires are disconnected the unbolt it. It is so much easier with a helper.
Then reverse procedure. Good Luck
You will need to remove the speaker covers in your 2006 Chevrolet Silverado. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
How do I remove the heatrest off of a 2000 LT Chevrolet Silverado
Unscrew it.
You shouldn't own a chevy if you can't figure out how to remove the bumper
ac and heating fan control switch is needing replaced. I need to know how to remove and re install new one on a 2005 chevy silverado Z71.
The push pins that are holding trim to the front bumper on a 2001 Silverado are actually pop rivets. These rivets have to be cut off to remove them. A hacksaw will be needed to accomplish this.
You remove the clips on the top, screws by the fenders, remove foglights if equiped and remove the bumper, install the new one in the opposite order.
To remove the front bumper from a Celebrity: 1. Raise the vehicle as needed and put on stands. The parking brake should be on. 2. Remove the end covers 3. Remove the valence cover. 4. Remove the nuts that hold the bumper to the mounting struts. Be careful to avoid having the bumper fall off onto you. 5. Remove the bumper. Reverse these instructions to put the bumper back on.
Begin by removing the retaining ring at the top of your 1996 Chevrolet Silverado ignition lock cylinder. Slide the ignition lock out and remove the wiring harness. Reverse the process to install your new ignition lock cylinder.
== # Remove screws attaching license plate lamp to rear bumper # Remove lamp from bumper. # Remove bulb socket from lamp. # Pull bulb from socket. == # Install bulb into socket. # Install bulb socket into lamp. # Place lamp in position. # Install screws attaching license plate lamp to rear bumper.
remove fuel tank.
In 1995 there were not any carburators as everything is fuel injection.