There are many brake lines especially if the vehicle has ABS brakes. The brake lines would run from the master cylinder to the ABS module, from there one to each wheel for 4 wheel disc brakes or for rear drum brakes, one to each front wheel and one to both rear wheels.
Disconnect brake line at the nearest junction Disconnect brake line at the affected wheel cylinder Route new brake line same way old one was Connect both ends Bleed the wheel cylinder on that line MAKE SURE MASTER CYLINDER DOES NOT RUN EMPTY
command.com command.com
brake vacuum line location on the 1991 oldsmobile regency 98
they run along the drivers side chassis, there are 5 of them
find the master cylinder and the brake line take the brake line off let all the fluid drain out then take the old one all the way off and put thenew back on
your rubber brake line at caliper is broken inside and will not let fluid return to master cylinder
It is on the front of the bell housing of the transmission. To find it trace a "brake line" fitting from the firewall to the bottom of the transmission bell housing.
you buy brake pads and you change them
brake light swith located under the brake pedal is stuck.
theres a ensor on top of the brake pedal that needs changin
your switch my need adjusted or replaced