There are several cogs which are geared in a certain way. When pulled back these turn to twist a spring or rubber ban around. This stores the energy and when released it turn the cogs the other way and propels the car forward.
Replace the pull=down switch to fix.
When you pull the handle a washer is lifted and the water goes down into the toilet and at the same time the cistern fills up once the washer is back in place from the flushing mechanism
That would be the trigger on most firearms, the slide on an automatic pistol, and the hammer on either an automatic pistol or a revolver. You also pull back the bolt on a rifle, and sometime the cocking mechanism on a shotgun.
Pull the breech back and in the same motion turn the safety pin counter clockwise when it reaches the locking gap. Turn the safety pen completely to the right and push the breech the rest of the way back pulling upward. The firing mechanism will slide back so as to facilitate putting the gun back together. Simply pull the firing mechanism back and push in when breech is put back into place and put the safety pin back into position
you can pull it back then let it go flying:) blackblake
open the hood pull back the cover from back casing on the light. take out the screws and hook the lighting mechanism from the wires and shes out. same with back lights but those are in the trunk and peel back the floor mat!!!!!!!!!!!!!!!!!!!
The mechanism doesn't work properly.
Pull down the back seat then insert a screwdriver in the hole in the middle of the lock mechanism and turn it until the trunk opens. On the left side of the mechanism is a plastic box that probably broke, replace it.
you have to pull back a little hard, or pull back the top orange part and take out the Nerf dart. if that doesn't work get a new gun.
To open the hood on a 1998 Volkswagen Beetle if the release mechanism is broken, it is necessary to remove the back seat and locate the broken part of the cord and pull on it. If the trunk mechanism breaks it will be necessary to crawl under the vehicle to locate the broken cord.
A slingshot mechanism is a small projectile weapon that you hold in your hand. It has a Y-shaped frame with a rubber strip attached to each fork of the Y. There is a pocket in the rubber strip that holds the projectile and you pull the rubber strip back to let the projectile fly.
Look at the back of the breech. If there isn't a hammer, it's hammerless. Hammers are those things that stick up at the back of the barrel. On a single action gun you have to cock them (pull them back) before you pull the trigger. Pulling the trigger cocks and releases the hammers on a double action. All the firing mechanism is inside a hammerless gun.