To open the hood on a 1998 Volkswagen Beetle if the release mechanism is broken, it is necessary to remove the back seat and locate the broken part of the cord and pull on it. If the trunk mechanism breaks it will be necessary to crawl under the vehicle to locate the broken cord.
"pop" the hood with the in car lever. get a pair of pliars and grab the wire that the plastic hood release was connected to.....this should work!
You must pull off the rear interior panel and manually release the mechanism. It can be difficult and cumbersome. Be certain to not break the plastic!
Have a helper pull the release handle while you look at the release mechanism. This will tell you if the cable is broken or if the problem is in the trunk mechanism.
Most likely the canceling mechanism, which is plastic and located under the steering wheel, is broken.
To open the hood on the 2000 Beetle if the hood release lever is broken inside the car, you can remove the glove compartment of the vehicle and find the release cable inside the dashboard. Pull the cable to open the hood. You will then need to replace the hood release lever.?æ
Just remove the plastic cover that is under the steering wheel, it has 3 screws and some snaps. then you can see the mechanism that the cable was pulling to release. it is a lever just reach in with a stiff wire with a hook on the end and hook it and pull towards you and it will release the brake.
The generic answer would be to first take a good look on the hood release mechanism on a similar car. Then get a good flashlight, look through the grille and see if there's a way of accessing the latch from there.
If its broken, then the cable is released. IF the breaks are still sticking, then the rear brakes will have to be opened up and the mechanism freed up.
SOLS JEWELRY & LOAN
If you remove the air dam underneath the front end (ahead of the radiator) then you should be able to reach and release the mechanism from under the car.
Remove carefully front grill with thin flat screwdriver to release tabs around it and you will access to the latch and pull cable end mechanism. Open it by pushing down on the hood while releasing the latch mechanism.
When the steering wheel unlocks,the shifter sometimes does not..Turn on key,see that the steering wheel is unlocked,then turn the wheel back andforth till the shifter releases.If it won't release,the plastic component in the column is broken. . .Very rarely does the plastic break,it just gets worn,thus making it hard to release. . .Parking on a hill without the Ebrake is what causes this to wear. . .Pull the upper column apart and replace the plastic mechanism and you will cure the problem. . . . . .