0
By blocking I guess you mean a wall supporting the joists.
Old school way is half the span plus 2, so if the span is 12 feet then half is 6 so add 2 to the 6 and you get 8, so the timber needs to be 8 inches deep.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What are the ends of the joist nailed too?
Floor joist or ceiling joist? Floor joist have a board on the end all the way along the side of the building called a rim joist. Like the cross bar on the top of a T. Ceiling joist are nailed down into the top plate of the wall and to the rafters where possible.
What is a load-bearing horizontal component?
Outside wall, inside partition wall, usually down the center of the house, header over a door or window, top and bottom plate in the wall, the floor the wall sits on, the rim joist the wall sits on, the floor joists, these are all horizontal load bearing features.
What is the purpose of floor joists?
In construction, a joist is a horizontal piece that runs from wall to wall, wall to beam or beam to beam. A joist is essentially considered to be one of the most supporting pieces towards the structural aspect. It focuses in on supporting beams and other pieces in the floor, ceiling and roof.
What is a crawl foundation in construction?
Instead of pouring a concrete slab for your floor you can have it built out of engineered i-joist. They do this by building concrete footings with a stem wall on top of that. They will then pour footings for pony walls or post and beams to support the i-joist's. They will then run the joist over the pony walls which will create your CRAWL SPACE. This also gives you the ability to fully insulate underneath the floor and have access to your plumbing if you run into problems with that later on. its also a little more forgiving when your children take those tumbles to the floor.
What is a wall to wall supporting beam called?
joist
Is it safe to put something weighing 1000 lbs on an inside wall?
that would all depend on what is under that wall. If it is running along a floor joist that is properly supported, then I would do it
What is softwood made up of?
Do you mean what can soft wood be used for. Here are some uses. Roof trusses/ floor joist/ ceiling joist/ stud partitions/ timber flooring/ wall strapping/ linning boards internal finnishing. ect
What is a band joist?
it is the board that is put on the top of the basement wall and then the side wall is built above that.adding foam to this joist helps to reduce air infiltration up to 25 percent.
Beams transfer loads from the joist to the?
beam transfer loads from the joist to the wall or column where it supports..
Typically joist are connected to wood beam using?
Nails. If they cannot be placed on top of a wall or beam a joist hanger is required as well.
Do non load bearing walls run parallel to ceiling joist or perpendicular?
Non load bearing walls can run any direction in a house. The thing that makes a wall load bearing is that it supports the weight of the structure and is usually at the endpoint of an upper floor joist. Sometimes these walls will be built out of 2"x6" lumber instead of 2"x4" as in regular walls.
How to run wire through joist?
Drill a hole large enough and pull the cable through. The hole must be 1-1/2" from the edge of the joist to prevent nails or drywall screws from penetrating the cable. If the hole is less than this distance, a nail plate must be installed over the edge of the joist so when the wall covering is added, a screw or nail can't penetrate the wire. Any hole drilled through a joist must be no more than a fifth of the depth of the joist and should be as near as possible to the centre of the joist. Holes bigger than 30mm are not recommended without specifically designed additional strengthening to the joist.
