answersLogoWhite

0


Best Answer

ABOUT A HALF AN INCH DOWN OR UNTELL THE EXTENDED RING SETS EVEN WITH INTAKE.... LOCATED-BACK LEFT SIDE

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How far down should the PCV go on the intake of a 1984 Oldsmobile Cutlass Supreme V6?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Doing tune up on a 77 Oldsmobile cutlass supreme need diagram layout plugs and wires?

Look on your intake for the firing order, it should be stamped on tht front raised section of the intake.


Does a 1996 Oldsmobile cutlass ciera with a 3.1 motor interchange with a 1995 Oldsmobile cutlass supreme 3.1 motor?

The 2.8, 3.1 and 3.4 are all the same block throughout all years. The only thing that really changed was the style of head, the intake, and a roller camshaft. It should be a direct swap for what you are wanting to do however.


What are some things to check when 1991 Oldsmobile Cutlass Supreme won't start?

The most obvious thing to check when a 1991 Oldsmobile Cutlass Supreme won't start is to make sure that the vehicle has gas. You should also check the battery. If the car clicks when you try to start it, it is likely the alternator.


How much fuel pressure should a 1990 Oldsmobile cutlass supreme have at idle?

I found it in my repair manual. It is about 26 to 32 psi.


Replace the radiator on 1993 Oldsmobile cutlass supreme sl?

After you remove top plate, hoses,trans lines, fan & shroud it should lift straight up.


How do you set the timing chain on an Oldsmobile Cutlass?

timing gearsI've been told by more than one person that my '91 Cutlass Supreme has timing gears instead of timing chain. . I looked in the book and you should have a timing chain.


Where is the low and high beam switch in a 1984 Oldsmobile Cutlass Supreme?

With the lights on pull on the turn signal lever. High beams should come on. Pull again and they should go off.


Where is the electronic flasher installed on a 1993 Oldsmobile Cutlass Supreme?

If the hazard control is in the dash--may be part of that module - it is in the newer GM vehicles If not it should be in or close to the fuse block


How do you get the trunk open on 1993 Oldsmobile Cutlass Supreme LS with factory installed security device and key will not turn lock?

Open the glove box, and there should be a button to pop your trunk


Would a 1995 Oldsmobile cutlass supreme not start if the air bags are diploid?

There is a fuel cut-off switch under the hood that needs to be reset. Should be on the left side near the back.


What size tires can you use on a 1995 Oldsmobile cutlass supreme?

Look inside the driver side door jam is should tell you tire sizes. If you cannot find it, refer to your owners manual.


Where is the cam sensor located on a 94 Oldsmobile ciera cutlass s?

The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.